Investment Risk/Return Calculator

Calculate the Sharpe Ratio, portfolio volatility, and risk-adjusted return relative to risk-free Treasury yields.

Measure your investment performance adjusted for volatility. Calculate the Sharpe Ratio to evaluate whether your portfolio’s excess returns adequately compensate you for the risk and market swings you endure.

How this calculator works

Sharpe Ratio = (Expected Return - Risk_Free_Rate) / Standard_Deviation. Classifies risk levels from Conservative (<6% SD) to Aggressive (>20% SD).

Key benefits

Assumptions & exclusions

Frequently asked questions

What is a good Sharpe Ratio?

A Sharpe ratio above 1.0 is considered good; 1.5 or higher is very good; and 2.0+ is considered excellent. A Sharpe ratio below 0.5 indicates you are taking on significant price volatility for relatively little excess return.

What does standard deviation mean on this page?

It is the volatility figure: how widely the portfolio's yearly returns scatter around their average, in percentage points. A standard deviation of 14.5% means a typical year lands noticeably above or below the average return, in either direction — it measures bumpiness, not loss.

Why subtract the risk-free rate before judging a return?

Because part of any return is available without taking market risk at all, from safe holdings. Only the return above that safe benchmark compensates you for volatility. Subtracting it first stops a portfolio from looking skilful merely because safe rates were high.

Can a portfolio have a negative Sharpe ratio?

Yes. If the expected or measured return falls below the risk-free rate, the excess return is negative and so is the ratio. It means the portfolio delivered less than a safe holding while still exposing the investor to swings — the worst of both combinations.

Does a higher Sharpe ratio mean a portfolio cannot lose money?

No. The ratio describes the relationship between past or assumed return and volatility; it is not a floor under future results. A portfolio with a strong ratio can still post a losing year, especially when the period used to compute the ratio was unusually calm.

Why can two portfolios with the same return have different Sharpe ratios?

Because the ratio divides excess return by volatility, and the two portfolios may have taken very different paths to the same average. The one with the calmer path — the lower standard deviation — earns the higher ratio, marking it as the more efficient of the two.

Formula-Based Calculator · By QalcTools Editorial Team. Formulas tested against independent reference values · Content reviewed November 2026 by the QalcTools Editorial Team.

Methodology note: William F. Sharpe modern portfolio risk-adjusted return equations.

Related calculators

Category: Investments & Retirement Calculators

About this calculator

A return figure on its own never says whether the ride was worth it. Two portfolios can both average 9 percent a year while one swings violently and the other moves calmly, and only the second earned its return efficiently. This calculator focuses on that missing half of the story: the Sharpe ratio, which measures how much return above a safe benchmark a portfolio delivers for each unit of volatility it imposes. Enter an expected return and the page pairs the risk measure with a growth projection of your starting capital and monthly contributions, so reward and risk stay on the same screen where they belong.

How it works

The risk calculation takes three percentages: your expected return, the portfolio’s volatility expressed as a standard deviation, and a risk-free rate representing what a safe holding would pay. It subtracts the risk-free rate from the expected return to isolate the excess return, then divides by volatility — the result is the Sharpe ratio. The engine also bands the volatility itself into a plain-language rating, from Very Low below 6 percent to Aggressive above 22 percent. Alongside it, the page projects your balance with a monthly growth simulation using your starting amount, monthly contribution, expected return and horizon, crediting growth each month and adding deposits at month-end.

The formula, explained

Sharpe ratio = (Expected return − Risk-free rate) ÷ Standard deviation

The engine floors the standard deviation at 0.01 percent so the division can never explode, subtracts the risk-free rate from the expected return, divides by volatility, and rounds the ratio to two decimals. The rating is assigned from volatility alone: under 6 percent is Very Low, under 14 percent is Moderate, under 22 percent is High, and anything above is Aggressive. On this page the volatility and risk-free inputs sit at built-in values of 14.5 percent and 4.25 percent, while the expected return is yours to set. The balance projection beside it is a separate monthly simulation and does not feed the ratio.

Inputs and variables

VariableMeaningExample
Expected Annual Return (%)The yearly return you anticipate from the portfolio. It is the figure being judged — the ratio asks what you had to endure to earn it.9% per year
Portfolio Volatility (Standard Deviation)How widely the portfolio’s returns swing around their average each year. On this page it is held at a built-in 14.5 percent, a level typical of a stock-heavy mix.14.5% per year
Risk-Free Rate (%)What a safe benchmark pays, held at a built-in 4.25 percent on this page. Only return above this line counts as compensation for taking risk.4.25% per year
Initial Invested CapitalThe starting balance for the growth projection shown beside the risk figures. It does not change the Sharpe ratio itself.$10,000
Regular Monthly ContributionThe deposit added at the end of each month in the balance projection, so you can see the plan the risk belongs to.$500 per month
Time Horizon (Years)How long the balance projection runs. Longer horizons give a volatile portfolio more time to recover from its swings.10 years

Worked example

An investor expects a portfolio to return 9% a year, assessed against the page’s built-in assumptions of 14.5% volatility and a 4.25% risk-free rate.

  1. Excess return: 9% − 4.25% = 4.75 percentage points earned above the safe benchmark.
  2. Sharpe ratio: 4.75 ÷ 14.5 ≈ 0.33 — about a third of a point of excess return for each point of volatility.
  3. Volatility rating: 14.5% sits in the engine’s High band, which covers 14% up to 22%, so the portfolio is priced as a genuinely bumpy holding.
  4. Context: the same 4.75 points of excess return at half the volatility (7.25%) would produce a ratio near 0.66, doubling the measured efficiency without any extra return.

A Sharpe ratio of 0.33 with a High volatility rating — 4.75 points of expected excess return spread across 14.5 points of volatility.

A ratio of 0.33 describes modest compensation: the portfolio is expected to beat a safe holding, but the margin is thin relative to the swings an investor must sit through to collect it. That does not make the portfolio wrong — a long horizon can justify bumpiness — but it sets the right question. Before accepting this risk level, compare it with a calmer mix: if a lower-volatility portfolio offers a similar excess return, its higher ratio marks it as the more efficient route to a similar destination.

Understanding your results

Read the ratio and the rating as two different warnings. The rating describes the ride itself — at 14.5% volatility, a bad year can plausibly sit far below the average, and the balance projection’s smooth line will not warn you about it. The ratio describes the pay for that ride. A High rating with a low ratio is the uncomfortable combination: maximum bumpiness, minimum compensation. A High rating with a strong ratio at least argues the risk is being paid for.

Comparisons are where the ratio earns its keep. It is only meaningful between portfolios measured over the same period with the same risk-free rate, because both the excess return and the volatility come from that window. A ratio built from a calm decade flatters any portfolio. When you test alternatives on this page, change the expected return and watch how much extra return a calmer or riskier mix must offer before its efficiency actually improves.

Assumptions and limitations

The ratio compresses risk into a single volatility number, so it treats a sudden crash and a gentle wobble of the same size as equivalent, and it says nothing about the worst loss an investor might face or how long recovery could take. Volatility measured from one period can shift sharply in the next, and the expected return is an assumption you supply, not a measurement. On this page the volatility and risk-free values are fixed built-in assumptions rather than figures drawn from your actual holdings, and the balance projection applies a smooth return with no taxes or fees deducted. Use the output to compare structures, not to certify any single portfolio.

Common mistakes to avoid

Sources

Related guides